33
When there is one battery LED lamp
Lighting pattern*1 Indication conditions Recovery Error code*2
(Repeatedly flashes 5 times)
Electrical abnormality in battery
detected.
Remove the battery charger after
connecting it to the battery. Make sure to
press the power switch with the battery
connected.
If an error is displayed for the battery
alone or E023 is displayed on the cycle
computer, have your place of purchase
perform the following.
•
Connect a genuine SHIMANO battery.
Also check the power cord for
abnormalities. If the error persists,
contact your distributor.
E023
(Repeatedly flashes 4 times)
Battery overcurrent protection
occurred.
Have your place of purchase perform the
following.
•
Connect a genuine SHIMANO battery.
Also check the power cord for
abnormalities. If the error persists,
contact your distributor.
E024
This is displayed if an error
occurs during charging.
Remove the battery charger from the
battery and press the power switch. If an
error is displayed, contact the place of
purchase.
No display
(Repeatedly flashes 3 times)
If the temperature exceeds the
guaranteed operating range,
the battery output is turned
off.
If the temperature is higher than the
temperature at which discharging is
possible, leave the battery in a cool
location with no direct sunlight until the
internal temperature of the battery has
decreased sufficiently. If the temperature
is lower than the temperature at which
discharging is possible, leave the battery
indoors until the internal temperature has
increased to an appropriate temperature.
W200
(W020)
(Repeatedly flashes 1 time)
Battery does not recognize the
drive unit.
Have your place of purchase perform the
following.
•
Connect a genuine SHIMANO battery.
Also check the power cord for
abnormalities. If the error persists,
contact your distributor.
E025
*1
: Flashing
*2 Displayed on the cycle computer.
The lighting pattern displayed in
parentheses may be displayed,
depending on the drive unit that
is connected.
To Next Page
Loading...
