69
Return to index page
Sun Gear1
13. Install Sun Gear1.
14. Install the carrier unit.
Do this while turning the cassette joint until it
makes contact.
If a shifting lever is connected, do this with the
unit in 1st gear.
NOTICE
• The carrier unit is structured from the following parts. •Apply grease to the areas indicated in the figure.
Carrier2 Unit
Ring Gear2
Ring Gear1 washer*
Sun Gear3
Sun Gear2 guide ring
Sun Gear1 guide ring
Ring Gear1
Carrier1 Unit
Sun Gear1
(Y-04130100)
(Y-04130100)
Assembling the Internal Assembly
* The Ring Gear1 washer is included only when the rst two
letters stamped on the hub axle are “RE - RL, SA - SL, or TA
- TL“. When reassembling the product, ensure that the part
conguration at the time of disassembly is maintained.
To Next Page
Loading...
