Adjusting when the setting value is [0]
Adjust the setting value one step at a time with [0] as the reference value.
Setting menu ⇒ [Adjust] ⇒ check the current setting value
*
Switch unit integrated type: With [GEAR] displayed, press and hold <A> on the cycle computer until the
display switches to [ADJUST].
Clamp band type
(SC-EN600)
cycle computer example
Switch unit integrated type
cycle computer example
(SC-EN500)
Value is [0]: Proceed to “ Adjusting when the setting value is [0] .”
Value is not [0]: Proceed to “ Adjusting when the setting value is not [0] .”
1.
<▲><▼> (adjust the setting value by one step)
Clamp band type
(SC-EN600)
cycle computer example
Switch unit integrated type
cycle computer example
(SC-EN500)
1.
Maintenance
Gear shifting adjustment with the electronic gear shifting unit [Adjust]
53
To Next Page
Loading...
Need help?
General