Shure Incorporated
25/37
1.
2.
3.
1.
2.
3.
1.
2.
3.
To activate Remote ID:
Momentarily press the link button on the transmitter or receiver.
The LCD of the linked receiver will blink and display ID and the status LED on the linked transmitter will flash red/green.
To exit Remote ID mode, momentarily press the link button or allow the function to timeout.
Manually Selecting a Group and Channel
Specific groups and channels can be assigned to the receiver instead of using the automatic scan function.
Note: Group 3 should only be used in controlled Wi-Fi environments to prevent interference from unexpected Wi-Fi devices.
Selecting a Group
Press and hold the group button for 2 seconds until the group display flashes.
Press the group button to scroll through the available groups.
The receiver will automatically save the selected group.
Selecting a Channel
Press and hold the channel button for 2 seconds until the channel display flashes.
Press the channel button to scroll through the available channels.
The receiver will automatically save the selected channel.
Note: A double dash symbol-- displayed on the receiver screen during a channel scan indicates that there are no available channels within the selected group.
Choose a group with more channels and repeat set up steps.
Firmware
Firmware is embedded software in each component that controls functionality. Periodically, new versions of firmware are devel
oped to incorporate additional features and enhancements. To take advantage of design improvements, new versions of the
firmware can be downloaded and installed using the Shure Update Utility tool.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
