Shure Incorporated
37/100
•
1.
2.
3.
4.
5.
Important: Alwaysperforma"walkaround"testtoverifycoveragebeforeusingawirelesssystemduringaspeechorperfor
mance. Experiment with antenna placement to find the optimum location. If necessary, mark "trouble spots" and ask presenters
or performers to avoid those areas.
Cardioid RF Pattern
Securing to a Wall or Ceiling
Required Equipment
Two #8 screws at appropriate length*
*Screw Length = Surface thickness + thread engagement (4.75 mm max.) + thickness of flat washer + the thickness of the split lock washer
General Installation Steps
Use the mounting plate as a template and mark the location for the holes.
Drill the holes into the mounting surface.
Secure mounting plate to the surface.
CAUTION: Do not over-tighten screws, as this could cause permanent damage to the charging station
Connect of the Ethernet cable to the MXWAPT using the cable route path.
Position the MXWAPT over the keyway slots of the mounting plate and slide it down into the locked position.
To Next Page
Loading...
Need help?
General
