Shure Incorporated
74/100
◦
◦
◦
◦
◦
◦
◦
◦
Preferences Tab
All preferences apply to each device in the Configuration.
① Switch Behavior
Customize the switch on each transmitter type.
Toggle (default): Press and release the button to change the status to Active or Mute.
Push-to-talk: Hold button to pass audio.
Push-to-mute: Hold button to mute the audio.
Disabled: The button does not affect the audio.
② Initial State from Charger
Assigns the state for the transmitter after it has been removed from the charger:
Active: On and passing audio to the network.
Mute: On but the audio is muted.
Standby: On but in a 'sleep' state with audio muted. Standby conserves battery charge and enables a change to the
transmitter's status from the control software.
Off: Power is off. A transmitter in this state cannot be remotely controlled by the software.
Note: These settings only apply to standard mode; transmitters in high efficiency mode are always powered off when removed from the changer.
③ Active/Mute LED Behavior
To Next Page
Loading...
