8. Position the explosion-proof enclosure on the two screws so that the mounting
hole
s are directly over the partly-tightened screws.
Figure 32: Step 8
9. Secure the upper end of the explosion-proof enclosure to the upper alignment
br
acket using two M8 screws.
10. Tighten the two lower screws.
Figure 33: Steps 9 and 10
11. Turn the sender and receiver so that they face one another and so that the
r
eceiver receives the strongest signal possible.
MOUNTING 5
8017023/14Q6/2020-04-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTec4 Core Ex
41
Subject to change without notice
To Next Page
Loading...
