SICK deTec4 Ex - Mounting the Safety Light Curtain Without Alignment Bracket

b
Mak
e sure that the sender and receiver are aligned correctly. The optical lens sys‐
tems of the sender and the receiver must be located opposite one another.
b
If necessary, use a spirit level to check that the components are parallel.
Further topics
•
"Minimum dis
tance from the hazardous point", page 25
•
"Minimum distance to reflective surfaces", page 27
•
"Sender and receiver alignment", page 68
5.7.1 Mounting the safety light curtain without alignment bracket
4 x
4 x
WS
13 mm
Scope of delivery
Required tools
Figure 32: Mounting the safety light curtain without the alignment bracket
Approach
b
Use w
rench size 13 mm.
Figure 33: Mounting the safety light curtain without the alignment bracket: Step 1
1. Using 6 to 8 revolutions, screw in the two M8 screws for mounting the lower end of
t
he explosion-proof enclosure. Make sure you leave enough space between the
screws and the mounting surface for the lower end of the explosion-proof enclo‐
sure.
5 MOUN
TING
50
O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex 8022883/2019-03-07 | SICK
Subject to change without notice