7 Configuration
7.1 Overview
Important information
Table 9: Functions and their configuration type
Function Configuration type
Beam coding DIP switch
Set to factory settings
Restart interlock Wiring
External device monitoring (EDM)
Status indication on both sides
The following system plugs are available for configuring via a DIP switch:
•
SP1 s
ystem plug
OFF
uncoded
code 1
code 2
ref.conf.
ON
1
O N
2
Figure 45: SP1 system plug with 2 DIP switches
Table 10: Overview of DIP switches
DIP switch Function
1, 2
•
Be
am coding, see "Configuring beam coding", page 62
•
Reset to factory settings, see "Reset to factory settings",
page 61
Further topics
•
"S
ystem plug", page 17
•
"Configuring the restart interlock", page 63
•
"Configuring external device monitoring (EDM)", page 64
•
"Status indication on both sides", page 65
7.2 Factory settings
Table 11: Configurable functions when delivered
Function Configuration when delivered
Beam coding. Uncoded
Restart interlock Not configured
External device monitoring (EDM) Not configured
7 CONFIGURATION
60
O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex 8022883/2019-03-07 | SICK
Subject to change without notice
To Next Page
Loading...