SICK deTec4 Ex - Sender and Receiver Alignment; Aligning the Sender and Receiver

Further topics
•
"C
onfiguration mode", page 62
•
"Indications when switching on", page 79
8.4 Sender and receiver alignment
Overview
Af
ter mounting and electrical installation, the sender and receiver must be aligned with
each other.
Important information
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during the alignment process.
b
Make sure that the outputs of the safety light curtain do not affect the machine
during the alignment process.
NOTE
W
hile aligning to the indication of the alignment quality, pay attention to the synchro‐
nization indication of the topmost and bottommost beam and the bracket with which
the sender and receiver are attached.
Further topics
•
"Indication of the alignment quality", page 71
•
"Diagnostic LEDs", page 79
8.4.1 Aligning the sender and receiver
Important information
DANGER
D
angerous state of the machine
b
Make sure that the dangerous state of the machine is (and remains) switched off
during the alignment process.
b
Make sure that the outputs of the safety light curtain do not affect the machine
during the alignment process.
DANGER
H
azard due to lack of effectiveness of the protective device
The integrated laser alignment aid switches the OSSDs to the OFF state.
b
Make sure that the outputs of the safety light curtain do not have any effect on the
machine when the integrated laser alignment aid is activated.
b
Only use the integrated laser alignment aid to align the safety light curtain.
8 COMMISSIONING
68
O P E R A T I N G I N S T R U C T I O N S | deTec4 Ex 8022883/2019-03-07 | SICK
Subject to change without notice