SICK DT50-2 Pro - Page 27

Manually teach in the desired distance as a single or DtO switching point for Q
2
Operating example or steps:
RUN mode
→ Q
1
Output
/ to → Q
2
Output
→ Function Q
2
/Q
a
/ to → Manual Q
2
→ Q
2
→ 30000 (Note: 3 = flashing 3)
/ , / , / , / ,
/ → desired distance in mm
→ Saved
to → RUN mode
Necessary default settings:
Function Q
2
/Q
a
= Switching
ModeQ
2
= DtO (1point)
Factory setting:
-
6.4.1.2 “Switching window” (“Window”) switching mode
6.4.1.2.1 Description
Output of a switching signal if the measured distance is inside (High Active) or outside
(Low Active) of a switching window.
Min Max
1 3
1
0
2
Sensor
Figure 12: High Active switching window
1
Switching point near
2
Switching point far
3
Middle of switching window
Min Max
1
1
0
2
Sensor
3
Figure 13: Low Active switching window
1
Switching point near
2
Switching point far
3
Middle of switching window
NOTE
If the sensor is unable to measure (e.g. the object is in a blind spot of the sensor, there
is too little remission or light reflection), a switching signal is output in the “Switching
window” (“Window”) switching mode, which corresponds to the expected behavior with
the maximum distance.
OPERATION 6
8017154/1AVV/2021-03-24 | SICK O P E R A T I N G I N S T R U C T I O N S | DT50-2 Pro
27
Subject to change without notice