a: f = 9.6 mm
b: f = 17.1 mm
0
200 x 160
400 x 320
600 x 480
800 x 640
1000 x 800
1200 x 960
0 200 400 600 800 1000 1200 1400 1600 1800 2000
a
b
0.1
0.3
0.5
0.6
0.7
0.8
0.9
Working distance/focus position (mm) 4
Field of view: H x V (mm) 1
Complete area 2
5
0.4
0.2
Approx. resolution (mm/px) 3
6
7
8
Figure 10: Example of field of view diagram
1
Field of view: horizontal x vertical in mm
2
Complete area
3
Approximate resolution in mm/px
4
Working distance/Focus position in mm
5
Selected resolution
6
Focal length of lens, here example for f = 9.6 mm
7
Reading off: resultant maximum working distance
8
Reading off: resultant field of view (mm x mm)
Given (in red):
•
Resolution 5: approx. 0.5 mm/px
•
Focal length of lens 6: 9.6 mm
Read off (in green):
•
Maximum working distance 7: approx. 930 mm
•
Field of view 8: approx. 640 mm x approx. 510 mm
Both axes of the diagrams must be interpreted linearly.
5.4
Mounting the device
1. Mount the device in a suitably prepared mounting system with M5 screws using
the threaded mounting holes or sliding nuts provided.
°
Screw the screws no more than 5 mm into the threaded mounting holes or
sliding nuts.
°
Use the threaded mounting holes in pairs on the top or bottom of the device
or the two sliding nuts on the side of the device.
°
Attach the separately-ordered, optional SICK mounting system using the slid‐
ing nuts on the device. Mounting systems are available as accessories, see
"Accessories", page 49.
2. Align the device taking into consideration the field of view (see "Field of view
diagrams", page 22) and the application circumstances (see "Installation require‐
ments", page 21).
3. Connect the device to interfaces and supply voltage when disconnected from
voltage, see "Connecting the device", page 32.
5 MOUNTING
24
O P E R A T I N G I N S T R U C T I O N S | InspectorP62x 8024439/1EJ6/2022-02 | SICK
Subject to change without notice
To Next Page
Loading...
