Pin Signal Function
9 SensGND Digital input ground
10 Sensor 1 Digital input 1
11 RD+ (RS-422/485), host Host interface (receiver+)
12 RD– (RS-422/485), host
RxD (RS-232), host
Host interface (receiver–)
13 IN/OUT 3 Digital input/Digital output 3 (configurable)
14 IN/OUT 4 Digital input/Digital output 4 (configurable)
15 Sensor 2 Digital input 2
16 IN/OUT 5 Digital input/Digital output 5 (configurable)
17 IN/OUT 6 Digital input/Digital output 6 (configurable)
– – Shield
“Ethernet” connection
Figure 19: M12 female connector, 4-pin, D-coded
Table 6: Pin assignment of the “Ethernet” connection
Pin Signal Function
1 TD+ Sender+
2 RD+ Receiver+
3 TD– Sender–
4 RD– Receiver–
6.6 Connecting the device
6.6.1 Using CDB and CDM connection modules
Table 7: Possible combinations of device and connection modules
Connection on the device Connection modules Connection cable
Male connector, M12, 17-pin, A-
coded
CDB650-204 Cable 1:1
1)
CDM420-0006
2)
Adapter cable
3)
1)
Connection cable 1:1 (female connector, M12, 17-pin, A-coded / male connector, M12, 17-pin, A-coded).
2)
CDM420-0007: for connecting 2 devices.
3)
Adapter cable (female connector, M12, 17-pin, A-coded / male connector, D-Sub-HD, 15-pin).
Connecting device with connection module
Connection modules Reference
CDB650-204 see "Connection of the device to CDB650-204", page 52
CDM420-0006 see "Connection of the device to CDM420-0006", page 59
6 ELECTRICAL INSTALLATION
32
O P E R A T I N G I N S T R U C T I O N S | InspectorP62x 8024439/1EJ6/2022-02 | SICK
Subject to change without notice
To Next Page
Loading...
