SICK KTML Series - Hazard Warnings and Operational Safety; Repair

Activities Qualification
Mounting, maintenance
■
Basic practical technical training
■
Knowledge of the current safety regulations in the workplace
Electrical installation,
dev
ice replacement
■
Prac
tical electrical training
■
Knowledge of current electrical safety regulations
■
Knowledge of the operation and control of the devices in their
particular application
Commissioning,
conf
iguration
■
Basic k
nowledge of the design and setup of the described con‐
nections and interfaces
■
Basic knowledge of data transmission
■
Knowledge of the operation and control of the devices in their
particular application
Operation of the devices in
their par
ticular application
■
Know
ledge of the operation and control of the devices in their
particular application
■
Knowledge of the software and hardware environment in the
application
2.5 Hazard warnings and operational safety
Please observe the safety notes and the warnings listed here and in other chapters of
t
he
se operating instructions to reduce the possibility of risks to health and avoid dan‐
gerous situations.
2.6 Repair
The product is a replacement device. The device is not intended to be repaired. Interfer‐
ence wit
h or modifications to the device on the part of the customer will invalidate any
warranty claims against SICK AG.
SAFETY INFORMATION 2
8025181/09.01.2020 | SICK O P E R A T I N G I N S T R U C T I O N | KTML
9
Subject to change without notice