3
Heat-shrinkable sleeve
6.2 Preparing the electrical installation
To carry out the electrical installation, you will need:
•
Connection cables for the peripheral devices, including the corresponding data
sheets
•
Voltage supply cable
•
If customers assemble the cables: crimping tool, ferrules, soldering iron, and other
installation material
6.3 Assembling the cables (optional)
NOTE
For a list of cables suitable for use with the device, see: supportportal.sick.com or visit
www.sick.com Customer assembly of the cables is only necessary in special cases.
Ensure a sufficient length of cable is provided, e.g., for strain-relief clamps.
NOTICE
Risk of damage/malfunction due to incorrect PIN assignment
Incorrect wiring of the male connectors/female connectors can lead to damage to or
malfunctions in the system.
■
Observe data sheets provided by the cable manufacturer.
■
Observe the pin assignment.
6.4 Overview of connections
Figure 5: Overview of connections
1
Terminal block 1 and 2
2
Terminal block 3 and 4
ELECTRICAL INSTALLATION 6
8023299/1BLK/2021-07-28 | SICK O P E R A T I N G I N S T R U C T I O N S | SIM1000 FXA, SIM1000 FXG
19
Subject to change without notice
To Next Page
Loading...
