10 Decommissioning
10.1 Removing the module
•
Remove the plug-in terminals along with the wiring and the end pieces.
•
When using the SIM1000 FXG: The Flexi Soft modules must be pushed approxi‐
mately 10 mm apart before a module can be removed from the DIN mounting rail.
•
Push the module down at the back (1). With the module still pushed down, move it
in the direction of the arrow to remove it from the mounting rail (2).
Figure 6: Removing the module, example
10.2 Disposal
CAUTION
Risk of injury due to hot device surface.
The surface of the device can become hot during operation.
■
Before commencing disassembly, switch off the device and allow it to cool down
as necessary.
If a device can no longer be used, dispose of it in an environmentally friendly manner
in accordance with the applicable country-specific waste disposal regulations. Do not
dispose of the product along with household waste.
NOTICE
Danger to the environment due to improper disposal of the device.
Disposing of devices improperly may cause damage to the environment.
Therefore, observe the following information:
■
Always observe the valid regulations on environmental protection.
■
Separate the recyclable materials by type and place them in recycling containers.
DECOMMISSIONING 10
8023299/1BLK/2021-07-28 | SICK O P E R A T I N G I N S T R U C T I O N S | SIM1000 FXA, SIM1000 FXG
27
Subject to change without notice
To Next Page
Loading...
