Port 2: 1 GBit/s
Port 3: 100 MBit/s
Port 4: 1 GBit/s
NOTICE
Shielded Ethernet cables must be used. The shielding of the Ethernet cables must be
connected to functional earth.
6.6 Connecting peripheral devices
The device can be connected to a wide range of sensors and cameras.
The required pin assignments can be found in the data sheets for the peripherals to be
connected as well as in the relevant connection descriptions, see "Pin allocation of the
connections", page 20.
1. Connect the cables to peripheral devices.
2. Route the cables to the device using installation materials (cable channels, cable
ties, etc.). When doing so, pay attention to cable strain relief.
3. Connect cables to the relevant device connections and screw together tightly.
6.7 Connecting voltage supply
NOTICE
Risk of damage to peripheral devices!
If peripheral devices are connected when the voltage supply is also applied, these
devices can become damaged.
■
Only connect peripheral devices when the voltage supply is disconnected.
1. Ensure that the voltage has been disconnected by the user.
2. Connect the voltage supply cable(s) to the device.
3. Lay the cable(s) with strain relief.
4. Have the user connect the voltage supply.
5. Have the user activate the voltage.
6 ELECTRICAL INSTALLATION
22
O P E R A T I N G I N S T R U C T I O N S | SIM1000 FXA, SIM1000 FXG 8023299/1BLK/2021-07-28 | SICK
Subject to change without notice
To Next Page
Loading...
