In open state, the device does not conform to a specified enclosure rating. The device
must be protected appropriately against moisture and dust. To ensure compliance
with the specified IP67 enclosure rating, see see "Mounting a microSD memory card",
page 18
For further warranty provisions, see the General Terms and Conditions of SICK AG, e.g.
on the delivery note of the device.
2.6 Cybersecurity
Protection against cybersecurity threats requires a comprehensive and holistic cyberse‐
curity concept that must be continuously monitored and maintained. Such a concept
consists of organizational, technical, process-related, electronic and physical defense
levels and sets up appropriate measures for the different types of risk. SICK's products
and solutions must be regarded as an integral part of this concept.
Information on Cybersecurity can be found at: www.sick.com/psirt .
2.7 Requirements for skilled persons and operating personnel
WARNING
Risk of injury due to insufficient training.
Improper handling of the device may result in considerable personal injury and material
damage.
■
All work must only ever be carried out by the stipulated persons.
This product documentation refers to the following qualification requirements for the
various activities associated with the device:
■
Instructed personnel have been briefed by the operator about the tasks assigned
to them and about potential dangers arising from improper action.
■
Skilled personnel have the specialist training, skills, and experience, as well as
knowledge of the relevant regulations, to be able to perform tasks delegated to
them and to detect and avoid any potential dangers independently.
■
Electricians have the specialist training, skills, and experience, as well as knowl‐
edge of the relevant standards and provisions, to be able to carry out work on
electrical systems and to detect and avoid any potential dangers independently.
The electrician must comply with the provisions of the locally applicable work
safety regulation.
The following qualifications are required for various activities:
Table 1: Activities and technical requirements
Activities Qualification
Mounting, maintenance
■
Basic practical technical training
■
Knowledge of the current safety regulations in the workplace
Electrical installation,
device replacement
■
Practical electrical training
■
Knowledge of current electrical safety regulations
■
Knowledge of the operation and control of the devices in their
particular application
Commissioning, configura‐
tion
■
Basic knowledge of the computer operating system used
■
Basic knowledge of the design and setup of the described
connections and interfaces
■
Basic knowledge of data transmission
■
Knowledge of the programming of image-processing systems
and network components
2 SAFETY INFORMATION
10
O P E R A T I N G I N S T R U C T I O N S | TriSpectorP1000 8022395/19OK/2020-12 | SICK
Subject to change without notice
To Next Page
Loading...
