SICK WLL80 Analog - Mounting; Scope of Delivery; Mounting Requirements; Connecting Fibers

5 Mounting
5.1 Scope of delivery
•
Device in the version ordered (including mounting bracket, if applicable)
•
Quick start guide
•
Safety notes
The fibers are not included with delivery.
5.2 Mounting requirements
•
Typical space requirement for the device, see type-specific dimensional drawing, see "Technical data",
page 71.
•
Comply with technical data, such as the permitted ambient conditions for operation of the device (e.g.,
temperature range, EMC interference emissions, ground potential),
•
To prevent condensation, avoid exposing the device to rapid changes in temperature.
•
Protect the device from direct sunlight.
•
shock and vibration-free mounting
5.3 Connecting fibers
4
5
6
1
3
2
Figure 4: Connecting fibers
1.
Open the fiber locking mechanism1.
2.
Insert the fibers 4 into the openings provided (see receiver and sender symbol on the housing) 2+5as far
as they will go (check the indicator for correctly inserted fibers 6).
3.
Close the fiber locking mechanism 3.
NOTICE
When using a fiber optic proximity variant with a coaxial fiber arrangement, connect the single-core optical fiber to
the sender. Connect the multi-core optical fiber (fiber bundle) to the receiver.
5 MOUNTING
10
O P E R A T I N G I N S T R U C T I O N S | WLL80 Analog 8027947 /2022-12-14 | SICK
Subject to change without notice