SICK WLL80 Analog - Mounting;Removing the Sensor

5.3.1 Use fibers with thin end sleeves
1
2
3
Figure 5: Fiber with thin end sleeve
1
Fiber with thin end sleeve
2
Separation position
3
Adjustment cap
1.
Turn the adjustment cap 3fully counterclockwise. Insert the optical fiber 1.
2.
Turn the adjustment cap 3 clockwise to lock it.
3. Cut off any excess optical fiber.
5.4 Mounting/removing the sensor
Mounting
1
2
Figure 6: Mount the WLL80 on the DIN rail
1. Hook the lug of the sensor into the DIN rail/mounting bracket
2. Press the sensor in the direction of arrow 2 until the spring clip locks onto the DIN rail/mounting bracket.
Removing
1
2
Figure 7: Remove the WLL80 from the DIN rail
MOUNTING 5
8027947 /2022-12-14 | SICK O P E R A T I N G I N S T R U C T I O N S | WLL80 Analog
11
Subject to change without notice