SICK WLL80 Analog - General Sensor Functions

8.2 General sensor functions
Standby mode
Table 10: Standby mode
1
A
|
1234
100
120 sec.
without button
operation
Run mode
any
button
1
A
|
1234
100
Standby mode (dimmed display)
Standby mode
After 120seconds without button operation, the sensor switches to
standby mode and dims the display to 20% brightness (the display is
turned off completely when energy-saving mode is activated). Pressing any
button wakes up the display from standby mode and returns the device to
run mode.
Locking the sensor
Table 11: Sensor lock
1
A
|
1234
100
Run mode (unlocked)
1 sec.>1 sec.
1
A
|
Lock
1
A
|
1234
100
Run mode (locked)
Sensor lock
Lock and unlock the sensor by pressing and holding (center of the
button for >1second).
1
A
|
Lock
Sensor locked
1
A
|
Unlock
Sensor unlocked
NOTE
Under the Input/Output settings, it is possible to configure lock options
that are activated when the sensor is locked (lock operating buttons and
lock external input).
8 OPERATION
22
O P E R A T I N G I N S T R U C T I O N S | WLL80 Analog 8027947 /2022-12-14 | SICK
Subject to change without notice