26
Caution
• If the bed has come from a storage / transport temperature
environment near to the minimum or maximum values stated
allow the bed to adjust to room temperature for a minimum of
2 hours prior to plugging the bed into the mains supply - Risk of
electrical system damage if operated outside of the recommended
temperatures.
• Do not use the side rails to move the bed – Side rail / bed frame
could be damaged.
• Avoid placing the bed frame in direct sunlight - Direct sunlight
could damage the electrical system and / or cause the bed to fade
in colour over time, including fading of the bed labelling.
• Avoid placing the bed frame in a moisture rich environment –
Prolonged exposure to moisture could damage the electrical
system and / or have a detrimental affect on the bed frame
components.
• Special care should be taken when fitting an air mattress to the bed
as incorrect fitting could damage the bed frame.
• The bed is not designed to run off battery power for long periods
(SOLITE/PRO/BB and SOLITE/PRO/LOW/BB only) and should
always be plugged into the mains supply during normal use -
Allowing the battery to discharge fully may impair its performance.
• When the bed is operated, ensure that obstacles such as over bed
tables and other furniture are not causing an obstruction.
• Ensure the bed is positioned an appropriate distance from walls/
other furniture to prevent equipment damage when operating the
bed (particularly when operating in tilt)
• If the bed is being used in conjunction with a hoist ensure the under
bed clearances are checked before lowering the bed to minimum
height - Risk of frames clashing.
• Special precautions regarding EMC need to be taken, the bed is to
be installed and put into service according to the EMC information
provided in section 17.
• After assembly of the bed there should be no parts remaining,
however consideration is to be taken in the event of spare
components (pins, clips etc.) being evident to minimise the risk of
them being swallowed by the bed occupant or any other person;
this could pose a choking hazard.
• Keep the bed away from sources of heat and naked flames (e.g.
cigarettes, fireplaces, electric fires, fan heaters etc.) – Close
proximity could damage the electrical system and / or pose a fire
hazard.
Warning
FOR AUTHORISED PERSONNEL REFERENCE ONLY
To Next Page
Loading...
