6
• Electrically operated backrest, height adjustment and leg rest angle.
• Auto regressing backrest.
• Electrically operated foot down tilt*.
• Auto contour – simultaneous adjustment of the backrest and leg rest section.
• Battery backup functionality (SOLITE/PRO/BB and SOLITE/PRO/LOW/BB only).
• Patient handset with individual function lockout.
• Integral mattress platform extension.
• Integral leg section extension.
• Optional integral full length side rails.
• Can be broken down into four separate sections.
• Transport stands to aid storage and bed transportation.
3.5 Features
* As standard, the handset provided omits the head down tilt (Trendelenburg)
function for safety reasons. If a Trendelenburg function is required a
replacement handset can be purchased featuring this function. Please refer
to section 18 for the part code, and refer to the contact information in section
2 to order or to request further information – Sidhil recommend the use of
the standard handset when the bed is being used in a domestic environment.
• The Solite Pro Low does not meet the upper height requirements of IEC
60601-2-52, if patient or carer requirements are such that the height range
is deemed to pose a potential hazard the Solite Pro should be used instead,
please refer to the contact information in section 2 to request further
information.
Warning
The handset operates an electronic linear actuator system, which is controlled via a central
control box. The actuators are attached to the moving parts of the bed frame allowing the bed
to be operated via the use of the handset.
Two powder coated steel bed ends support the mattress platform frame, the electrical system
and a set of side rails (when fitted) to provide patient protection; the bed has a safe working
load of 226kg. The bed is manoeuvrable via the aid of four individually lockable castors which
are attached to the bed ends, however it is not designed for patient transportation. The bed can
be disassembled into four separate sections, which can be assembled onto the transport stands
provided with the bed, aiding transportation and storage.
The Solite Pro range of beds are intended to be plugged into a permanent mains supply. A battery
backup version is available for such times that a mains supply is not available or reliable. A low
height version of the bed is also available, providing a solution where falls management is an
important consideration. The low height bed has a minimum and maximum mattress platform
height 100mm lower than the standard height bed.
The bed has one handset, intended for use by both the patient and carer, which provides the
carer with the ability to lock out the use of bed functions as necessary to reduce the risk of
accidental operation. It is the carer’s responsibility to determine that the patient is both mentally
and physically capable of operating the handset with minimal risk of personal injury.
3.4 Product Overview
To Next Page
Loading...
