21/2821/2802.2020H47.ELEKS014EN-00
GENIUS 2.2 PANIC, Electromechanical mul-point lock
7
• The mul-point lock and the oponal accessories
should not be disposed of with household waste.
Comply with the current local and naonal regula-
ons.
• The packaging consists of raw materials that can
be recycled and can be taken to the local recycling
disposal site.
Electrical devices should not be disposed of as house-
hold waste. Bring the device, accessories and packaging
to an environmentally-friendly recycling facility.
LED
lights up green
Disturbance-free
Flashes green
Opening signal is present
Flashes yellow
Faulty contact of the connecng
clamps
Check connecng clamps
Contact service partner if the
error persists.
Lights up yellow
Limited funcon
Contact service partner if the
fault persists.
Flashes yellow
Magnec sensor malfuncon
Manual adjustment of the mag-
nec sensor
(see assembly instrucons)
Contact service partner if the
error persists.
Flashes yellow/
green
Locking elements are extended
when the door is open
Release door before closing
Lights up red
Supply voltage defecve Check the supply voltage
If the fault persists
Contact service partner if the
fault persists.
Operang voltage exceeded Check the ambient temperature
Adjustment of magnec sensor
failed
Check posion of magnet
Lights up red
Error in the control unit
Contact service partner if the
fault persists.
Flashes red
Block drive with opening proce-
dure
Check for mechanical sluggish-
ness
If the fault persists
Contact service partner if the
fault persists.
Check free-running cylinder
Check locking elements for
smooth running
You can nd your regional partner on the following
website:
hps://www.siegenia.com/en/service/localdealer
6
You will nd further informaon on the operaon of
the GENIUS 2.2 PANIC (e.g. in conjuncon with the
SIEGENIA access control system) as well as all FAQs on
the topic of „SIEGENIA Smarthome“ on the following
SIEGENIA Internet page:
hps://smarthome.siegenia.com