Siegenia GENIUS 2.2 PANIC - Core Functions and Operation; Locking, Release, and Function Modes

7/287/2802.2020H47.ELEKS014EN-00

GENIUS 2.2 PANIC, Electromechanical mul-point lock
 
 
Opening in the direcon of escape is possible at any
me by acvaon of the lever handle or the horizontal
actuang bar.
Das Önen der Tür gegen die Fluchtrichtung ist erst
nach Entriegelung und Önen über den Schlüssel oder
der motorischen Önung über die GENIUS 2.2
PANIK Mehrfachverriegelung möglich. Aer using the
escape funcon, access against the direcon of escape
is blocked again once the door closes and it is not pos-
sible to escape back into the building.

• Emergency opening in the direcon of escape: open
door using the lever handle or horizontal actuang
bar.
• Opening against the direcon of escape: unlock and
open the door using the key. Turn the key to the
release stop.
• Locking in night mode: the door is automacally
locked when it is closed.
• Locking in day mode: there is no automac locking.
 
Opening in the direcon of escape is possible at any
me by acvaon of the lever handle or the horizontal
actuang bar.
Opening the door against the direcon of escape via
the lever handle is only possible aer unlocking with
the key or by using the motorised unlocking via the
GENIUS 2.2 PANIC mul-point lock.

• Emergency opening in the direcon of escape: open
door using the lever handle or horizontal actuang
bar.
4 
 
 

In day mode the door can be locked manually with the
cylinder key. All locking elements are extended in the
process.

In night mode the door is locked automacally when
it is closed. All locking elements are extended in the
process
 
The mul-point lock with GENIUS 2.2 PANIC can be
unlocked from the inside via the cylinder lock, the lever
handle, the horizontal actuang bar or via an oponal
access control system. For this purpose, the key must
be fully acvated as far as the release stop or the
relevant hardware or triggered via an opening impulse
from the access control system: all locking elements
including the latch are retracted.
• To lock or unlock the door with the cylinder key, always turn it
as far as it will go. The cylinder key must then be turned back
some way before it can be removed from the cylinder lock.
• If the door is released automacally, it remains open for 7 s
and an acousc signal will be audible for this period. If the
door is opened during this period, the signal tone will switch
o.
• The mul-point lock with GENIUS 2.2 PANIC will return to the
locking posion if the door is not opened during this period.
The mul-point lock with GENIUS 2.2 PANIC locks mechanically
automacally if the door is closed.
• Opening the door via cylinder lock, lever handle, or horizontal
actuang bar is only admissible during motor shutdown.
• Opening during the locking process leads to cancellaon. The
GENIUS 2.2 PANIC with cylinder operated lock E moves to the
"unlocked" posion and the latch is drawn into the cylinder
operated lock.
• The door must be opened and closed before it can be locked
electro-mechanically. The GENIUS 2.2 PANIC mul-point lock
then moves to the 'locked' posion.