Motor Components (Options)
4.6 Gearbox (option)
Ordering data:1FT6-A7-11 -Z
Prerequisite for mounting a planetary gear:
IP65, smooth motor shaft end, radial eccentricity tolerance N and vibration severity grade N.
Z = J (SP060S up to SP180S and SP210/SP240, horizontal type of construction)
Z = J + M1 (SP210 to SP240 in a vertical type of construction)
1)
Values for cyclic/positioning duty S3 60 %
2)
Referred to the center of the drive-out shaft
3)
Caution, oil quantities depend, for these versions, on the mounting position
for V types of construction, a "9" must be located at the 12th position of the Order No.
[MLFB] and a second code is required:
Type of construction IM V3: M1G
Type of construction IM V1: M1H
Continuous duty S1 (power-on duration > 60% or > 20 min.)
For continuous duty, corresponding to this definition, the limit values from the table below are
applicable for
• Motor speed n
1N
(
RPM
)
• Drive-out torques T
2N
(Nm)
• Gearbox temperature, max. 90°C
3ODQHWDU\JHDU
$YDLODEOH
VWDJH
*HDUUDWLRVL
7\SH
6360)
Q
1
7
1
6360)
Q
1
7
1
6360)
Q
1
7
1
6360)
Q
1
7
1
6360)
Q
1
7
1
630)
Q
1
7
1
630)
Q
1
7
1
3)
Caution, oil quantities depend, for these versions, on the mounting position for V types of
construction, a "9" must be located at the 12th position of the Order No. [MLFB] and a
second code is required:
Type of construction IM V1: M1H
Type of construction IM V3: M1G
1FT6 synchronous motors
4-14 Configuration Manual, (PFT6), Edition 12.2004, 6SN1197-0AD12-0BP0
To Next Page
Loading...
