Motor Description
1.8 Coupling output
1.8 Coupling output
The KTR company offers the pinion wheels of its Rotex GS couplings with various shore
hardnesses. The values specified in Table correspond to pinion wheels recommended by
KTR with a Shore hardness of 98 or 95 Sh A GS.
They must be optimally harmonized with the mounted mechanical system. A coupling pre-
selection is provided in Table . Please contact the coupling manufacturer for detailed design
information. Ordering address, refer to the Configuration Manual "General Section" or
Internet www.ktr.com.
Table 1-13 Assignment of the coupling outputs to the motors
98 Sh A GS
Shaft height of the
1FT6 motor
d
w
[mm]
1)
Rotex GS
Size
TKN [Nm]
2)
TKmax [Nm]
3)
TR [Nm]
4)
1FT602 9 9 5 10 2.6
1FT603 14 14 12.5 25 8.1
1FT6041 19 19 17 34 32
1FT6044 19 24 60 120 39
1FT606x–6A 24 24 60 120 43
1FT6062–6W 24 24 60 120 43
1FT6064–6W 24 28 60 120 91
1FT608x–8A 32 28 160 320 102
1FT608x–8S 32 28 160 320 102
1FT6084–8W 32 28 160 320 102
1FT6086–8W 32 38 325 650 113
1FT6102..5 38 38 325 650 122
1FT6108 38 42 450 900 ––
1FT613x–6A 48 42 450 900 ––
1FT613x–6S 48 42 450 900 ––
1FT6132..4–6W 48 48 525 1050 ––
1FT6136..8–6W 48 55 685 1370 ––
1FT6163 55 65 940
5)
1880
5)
––
1FT6168 55 75 1920
5)
3840
5)
––
1)
d
w
= diameter, motor shaft end
2)
T
KN
= rated coupling torque
3)
T
Kmax
= maximum coupling torque
4)
T
R
= friction-locked torque (torque that can be transmitted with a clamping hub at d
w
)
5)
values for 95 Sh A GS
Warning
The accelerating torque may not exceed the friction-locked torque of the coupling!
Notice
We cannot accept any liability for the quality and properties/features of third-party products.
1FT6 synchronous motors
1-28 Configuration Manual, (PFT6), Edition 12.2004, 6SN1197-0AD12-0BP0
To Next Page
Loading...
