Mounting
5.2 Fitting output elements
1FT7 synchronous motors
26 Operating Instructions, 04/2010, 610.40075.40b
Table 5- 1 Tightening torques
Motor Screw DIN 7984 Washer ISO 7092
[mm]
Tightening torque for screws (not for
electrical connections)
1FT703 M6 6 (d2 = 11) 8 Nm
1FT704 M6 6 (d2 = 11) 8 Nm
1FT706 M8 8 (d2 = 15) 20 Nm
1FT708 M10 10 (d2 = 18) 35 Nm
1FT710 M12 12 (d2 = 20) 60 Nm
5.2 Fitting output elements
NOTICE
Do not subject the motor's shaft and bearings to impact. Do not exceed the permissible
axial and radial forces at the shaft extension, as defined in the configuration specifications.
Axial forces are not permitted for motors with an integrated holding brake.
Suitable equipment (see figure) must be used when fitting and removing output elements
(e.g. coupling, gear wheel, belt pulley).
● Use a threaded hole in the shaft extension.
● If necessary, heat up the output elements.
● When removing output elements, use a washer to maintain the centering in the shaft
extension.
● If necessary, fully balance the motor with output elements in accordance with ISO 1940.
Figure 5-1 Fitting and removing output elements; A = washer (for maintaining the centering in the
shaft extension)
To Next Page
Loading...
