Operation
8.3 Stoppages
1FT7 synchronous motors
46 Operating Instructions, 04/2010, 610.40075.40b
8.3 Stoppages
Measures when motors are at a standstill and ready for operation
● If the motor is out of service for extended periods of time, run it at regular intervals
(roughly once a month) or at least spin the rotor.
● Refer to the section titled "Switching on" before switching on the motor to re-commission
it.
NOTICE
Damage due to improper storage
The motor can be damaged if it is not stored properly.
If the motor is out of service for extended periods of time, implement suitable anti-
corrosion and preservation measures and ensure that the motor is kept dry.
When re-commissioning the motor after a long non-operational period, carry out the
measures recommended in the chapter titled "Commissioning".
To Next Page
Loading...
