Connection
6.2 Electrical connection
1FT7 synchronous motors
34 Operating Instructions, 04/2010, 610.40075.40b
6.2.4 Rotating the connectors
Power connector, signal connector, and DRIVE-CLiQ can, to some extent, be rotated. A
suitable socket connector can be used to rotate the angle plug. Make sure that the socket
connector is completely secure to avoid damaging the pin contacts.
NOTICE
It is not permissible to exceed the specified rotation range.
In order to guarantee the degree of protection, max. 10 revolutions are permissible.
Connectors should be rotated using the matching mating connector located on the
connector thread. Only rotate the Sensor Module by hand. The use of pipe wrenches,
hammers, or similar is not permitted.
6
3
6
ar
6
3
3
6
)7[)7[)7[
)7[
)7[)7[
6L]H
6L]H
6L]H
)7[)7[
6L]H
Figure 6-4 Ability to rotate the connectors (P = power connector, S = signal connector)
Table 6- 3 Maximum rotating torques that occur
Connector M
max
Power connector, size 1 12 Nm
Power connector, size 1.5 20 Nm
Signal connector 12 Nm
DRIVE-CLiQ (connector) 8 Nm
The size 3 power connector cannot be rotated.
NOTICE
Cable outlet direction
If the direction of the cable outlet is not changed correctly, this can damage the connecting
cables. The direction of the cable outlet must not be changed since this renders all warranty
claims invalid.
To Next Page
Loading...
