iii
ET 200S Distributed I/O System
EWA-4NEB 780602402-12
Preface
Purpose of the Manual
The information in this manual is intended to enable you to operate the ET 200S
Distributed I/O System
• as a DP slave on the PROFIBUS DP
• as a PROFINET I/O device on PROFINET
Required level of knowledge
Knowledge of the field of automation engineering is required to understand the
manual.
Scope of the manual
This manual is valid for the components of the ET 200S distributed I/O system
specified in Appendix A.
This manual contains a description of the components that were valid at the time
the manual was published. We reserve the right to enclose a Product Information
bulletin containing up-to-date information about new components and new versions
of components.
Changes since the previous version
The following changes/additions have been made since the previous version of the
manual:
• enhanced functions in the IM151-1 STANDARD and IM151-1 FO STANDARD
interface modules
• 4AI I 2WIRE Standard analog electronic module added
To Next Page
Loading...
Need help?
General
