Siemens PM240-2_EN_rev00-30082019.docx 8-5
8.3 PARAMETERS CUSTOMIZATION
In the Parameter section you can edit, add and cancel a new or old list, and you can modify the value for
each parameter
8.3.1 Parameter value editing
In the Parameter section there are at least two screens: DEFINE and – in the example on the picture- USER.
Select the tab related to the function of interest, in which you can see and edit the enabled parameter list
(R=Read, P=Programmable), when you need
DO: shows the parameters of the Drive or the Control Unit
Parameter: contains the identification number of the parameter
Parameter text: describes the function of the parameter
Value: indicates the actual value or the one set
Change: allows you to change the value of the parameters.
Figure 25 SIEMENS S120, Parameter - User list
WARNING to edit the interesting parameter, click Change> Enter_New_value>Submit (to divide the
decimals use dot “.” not comma “,”).
The only parameters that you can edit are that starting with letter “p”.
Figure 26 SIEMENS S120, Parameter p21507 modify - New value
To Next Page
Loading...
