Siemens PM240-2_EN_rev00-30082019.docx 10-1
10 PROGRAMMING WITH KEYBOARD AND MENU
For simplicity it is preferable to perform the commissioning via PC using the STARTER software,
rather than setting the parameters from the operator panel. See Chapter Errore. L'origine
iferimento non è stata trovata..
10.1 BASIC OPERATOR PANEL BOP20
10.1.1 Description
The Basic Operator Panel BOP20 is an operator panel with six keys and a backlit display unit. The BOP20
can be inserted on the CU310-2 PN SINAMICS Control Units and operated.
The BOP20 supports the following functions:
Input of parameters and activation of functions
Display of operating modes, parameters, alarms and faults
10.1.2 Interface description
Figure 32 - Basic Operator Panel BOP20
Overview of displays and keys
Figure 33 - Overview of displays and keys
Table 14 Views
The active drive object of the BOP is displayed here.
The displays and key operations always refer to this drive object.
To Next Page
Loading...
