Siemens PM240-2_EN_rev00-30082019.docx 8-7
8.3.3 Add new parameters list
Select Define tab;
Click Add new list;
Set the name in List name;
Choose the parameters source (Control Unit or Drive)
Type the code of the interested parameter and if it is present select the relative index (example
p7764[0], p7764[1])
Click Add to introduce the new parameter.
Click Save list to save the modification at the end.
Figure 29 SIEMENS S120, Parameter - Define list
After adding and saving procedure, the new list name appear on the top. Click on the tab to see the
new list and to choose the parameter. For each line there are UP and DOWN buttons that allows to
move the parameter position on the parameters list. Click DEL to eliminate (Figure 30)
Figure 30 SIEMENS S120, Parameter – Define list
To Next Page
Loading...
