Communications 9410 series
4. Configure your meter’s SNMP parameters by selecting the parameter and clicking
Edit. Click OK in the editing screen to set the parameter value.
Parameter Description
Enable SNMP Enables or disables SNMP on your meter.
Enable Traps Enables or disables SNMP trapping on your meter.
Trap Rcvr Addr1 —
Trap Recvr Add4
Enter up to four trap receiver IP addresses where trap messages will be
sent.
Read only community Enter the community string used for SNMP get (read-only) requests.
Read write community Enter the community string used for SNMP set (read/write) requests.
NOTE: You can use the read/write community string for SNMP get (read-
only) requests.
System contact Enter the name of your SNMP system administrator.
System name Enter a descriptive name for your meter.
System location Enter your meter’s location.
5. Review the rest of the SNMP information and modify if necessary.
Related Topics
• Simple Network Management Protocol (SNMP)
Configuring SNMP using your meter’s webpages
You can configure SNMP trapping using your meter’s webpages.
You must download the ION MIB file from www.usa.siemens.com/pds.
1. Connect to your meter’s webpages.
2. Go to Setup > SNMP Parameters.
7EN05-0336-01 71
To Next Page
Loading...
