Siemens AT18 - Page 43

Operating Manual - Elevator Door Operation AT18
43
Total alignment
Prole parameter
Creep distance Open ... mm
Cutter distance Open ... mm
Creep distance Close ... mm
Cutter distance Close ... mm
Maximum speed Open ... mm/s
Creep speed Open ... mm/s
Cutter speed Open ... mm/s
Initial speed Open ... mm/s
Maximum speed Close ... mm/s
Creep speed
Close ... mm/s
Cutter speed
Close ... mm/s
Initial speed Close ... mm/s
Nudge speed
Close ... mm/s
Acceleration incline
Open ... mm/s
2
Braking incline Open ... mm/s
2
Reverse incline Open/Close ... mm/s
2
Acceleration incline Close ... mm/s
2
Braking incline Close ... mm/s
2
Reverse incline Close/Open ... mm/s
2
Permanent torque current Open ... mA
Permanent torque current
Close ... mA
Cutter push torque Close ... mA
Opening force static ... N
Closing force static ... N
Cutter force static
Close ... N
Nudge force static
Close ... N
continue on the next page