BC8001A Installation and Operating Instruction
Page 30/49
7. Press “↓” to choose one desired point and press “OK” key.
8. Press “↓” to choose “Te st ” / ”Walk-test” and press “OK” key.
Test status is shown.
9. Test work can be done now.
How to restore the test mode:
1~7 are the same as test.
8. Press “↓” to choose “Restore” and press “OK” key.
Test status is disappeared.
<Operate Points > L3 A
Isolate
Open
Te s t
Walk-test
To Next Page
Loading...
