206_58300000141095_ara_en_k.doc – 04.10.a Seite 105 von 113
5.23 Check supplied power for FlexInduction models
Warning!
:
The flexInduction hobs don´t understand of pots number. When it is
activated the flexi mode, the hob behaves like it had a unique pot on
the zone. For this reason, we can only give the total power of the
activated zones. We can not measure the power for each pot in the
zone.
In fact, for two kinds of pots, that is, with different material, placed in
the combisurface, the power given to each pot can be different.
5.23.1 Booster Function
The booster function for combisurface only use the left ELIN to give
the extra power. For this reason, there is only booster function, not
superbooster function. And we have booster, though we had pots on
the right zone.
5.23.2 Check supplied power
To be able to do the check, it is needed a pan of WMF brand and
base diameter 21 cm, with spare part number 570366.
We must place the pan in the quadrat inferior part and the supplied
power measures must be the following.
To Next Page
Loading...
