206_58300000141095_ara_en_k.doc – 04.10.a Seite 57 von 113
5.6 Checking the level of supplied power Problem
Low level of supplied power
Less power is supplied with the new inductor
5.6.1 Cause
The pot is not suitable. See list of suitable pots and check the
pot detection system.
The new IH5-I technology supplies less power than the old IH4-
I technology (ind IV). See regulations.
Certain regulations governing power have come into force. See
regulations.
The positioning spring that brings the inductors closer to the
glass is not in place.
See position of the spring.
5.6.2 Solution
5.6.2.1 Power regulation
5.6.2.1.1 Booster power regulation
For the first ten minutes, the Booster operates at maximum
power, in other words, it supplies 150% of inductor power.
Subsequently, the booster is regulated and lowered to power
level 9.
If the user wishes to reactivate the booster, this can be done.
The booster will supply maximum power for a further 2
minutes and then return to power level 9. After the 12
minutes with the booster at maximum power, if the user tries
to reactive it once more, only 83% of the 150% of inductor
power will be supplied and then it will return to power level 9
(100% inductor power).
At this time, if the user wishes to activate the booster again,
they must wait for the same period of time as the time they
wish it to be activated for, provided that this is less than 10
minutes.
Superbooster (Paella dish)
On these models, it is not possible to reactivate the booster
after the initial 10 minutes at maximum power.
If it has been used for 10 minutes, we must wait for 10
minutes in order to try and activate it again.
If we have used it for 5 minutes, we must wait for 5 minutes
in order to try and activate it again.
5.6.2.2
To Next Page
Loading...
