Siemens ET 200S - Page 345

Digital Electronic Modules
11-69
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Terminal Assignment
The following table indicates the terminal assignment of the 2RO NO
24–120 VDC/5 A, 24–230 VAC/5 A for the different terminal modules:
Table 11-18 Terminal Assignment of the 2RO NO 24–120 VDC/5 A, 24–230 VAC/5 A (as of Version 2)
View
Terminal Assignment Remarks
14
AUX1 (e.g. PE)
2
3
4
6
7
8
1
5
AUX1 (e.g. PE)
] ]
TM-E15S24-A1 and 2RO NO 24–120 VDC/
5 A, 24–230 VAC/5 A
CH1CH0
The AUX1 bus must
be applied to PE.
13
14
23
24
24
AA
Channel 0:
Terminals 1 to 3
Channel 1:
Terminals 5 to 7
13, 14: normally open
contact channel 0
23, 24: normally open
contact channel 1
Internal jumper between
terminals 2 and 3, 6 and 7
2
3
4
6
7
8
1
5
]
TM-E15S24-01 and 2RO NO 24–120 VDC/
5 A, 24–230 VAC/5 A
CH1CH0
14
13
14
23
24
24
n. c.n. c.
Channel 0:
Terminals 1 to 3
Channel 1:
Terminals 5 to 7
13, 14: normally open
contact channel 0
23, 24: normally open
contact channel 1
Terminals 4 and 8 can be
used for unneeded wires
up to the load voltage
used.
Internal jumper between
terminals 2 and 3, 6 and 7