Siemens ET 200SP HA - Parameters; 4.1 Parameter assignment

8. Con󹪝gure the PROFINET IO device ET 200SP HA with the exact same con󹪝guration as that of
the IO device ET 200SP HA in the project "Shared-Device-1" in the station "CPU1" (notes from
step 4.).
9. Save and compile the hardware con󹪝guration and close the hardware con󹪝guration in the
con󹪝guration tool and the project.
Result
The shared device is created. You assign the submodules to the con󹪝gured stations.
Note
Send clock
When using the shared device across multiple projects, make sure that the send clock for the
shared device is set to the same value in the projects. Otherwise, the shared device cannot be
adopted by the IO controller of the con󹪝gured station.
Assigning submodules
At least one submodule must be assigned to each station.
The submodules must be assigned separately for each station. Note that changes to one station
a󹪜ect other station(s).
Note
Access rules
A submodule may only be assigned to one IO controller at any given time in the hardware
con󹪝guration in the con󹪝guration tool. This means that the submodule in slot 4, for example,
can only be assigned to the "CPU1" with the setting "full access"; in "CPU2" the setting for the
submodule in slot 4 must therefore be "- - -" (corresponds to "no access").
1. Open the station of the IO controller "CPU1" of the project "Shared-Device-1" in the hardware
con󹪝guration in the con󹪝guration tool.
2. Open the properties of the PROFINET IO device.
3. Con󹪝gure the access to the individual submodules.
4. Save and compile the hardware con󹪝guration and close the hardware con󹪝guration in the
con󹪝guration tool and the project.
5. Open the station of the IO controller "CPU2" of the project "Shared-Device-2" in the hardware
con󹪝guration in the con󹪝guration tool.
6. Repeat steps 2 to 4.
Product overview
3.4 Shared Device
IM 155-6 PN HA
Equipment Manual, 09/2021, A5E39262148-AE 15