How possible damage to property is presented
Information about possible damage to property is shown as follows:
NOTICE
Nature and origin of the danger
Consequences if the danger occurs
● Measures / prohibitions for danger avoidance
2.2 Safety regulations for the method of operation
National standards, regulations and legislation
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional national or local
safety standards or legislation concerning the planning, mounting, installation,
operation or disposal of the product apply at the place of operation, then these
must also be taken into account together with the safety regulations in the product
documentation.
Electrical installations
WARNING
Electrical voltage
Electric shock
● Work on electrical installations may only be carried out by certified electricians
or by instructed persons working under the guidance and supervision of a
certified electrician, in accordance with the electrotechnical regulations.
● Wherever possible disconnect products from the power supply when carrying
out commissioning, maintenance or repair work on them.
● Lock volt-free areas to prevent them being switched back on again by mistake.
● Label the connection terminals with external voltage using a
'DANGERExternal voltage' sign.
● Route mains connections to products separately and fuse them with their own,
clearly marked fuse.
● Use an easily accessible disconnecting device in accordance with ENIEC
62368-1 outside the installation.
● Produce earthing as stated in local safety regulations.
CAUTION
Noncompliance with the following safety regulations
Risk of injury to persons and damage to property
● Compliance with the following regulations is required.
● Specialist electrotechnical knowledge is required for installation.
● Installation must be performed by a specialist.
If the installation is not performed properly, this could invalidate the electrical
safety precautions, which would not be obvious to non-experts.
Mounting, installation, commissioning and maintenance
● Any tools such as ladders must be safe and designed for the task in question.
● When starting up the fire control panel, check that no unstable states can
occur.
Safety
Safety regulations for the method of operation
2
A6V11783979_en--_a 9 | 48
To Next Page
Loading...
Need help?
General
