Siemens FDL241-9 - Safety; Safety instructions

-
+
Figure 9: Connection diagram for the source of DC voltage
3.2 Installing the detector base
WARNING
Danger of falling
Bodily injury
● When installing, use a secured ladder or work platform.
CAUTION
Using the device in a damp and/or corrosive environment
Device function is impaired.
● Use the M20x1.5 metal cable gland in damp and/or corrosive environments.
1
2
Figure 10: Mounting and electrical connection
1 Detector base 2 Carrier for connection terminals
1.
Break open the plastic parts in the detector base(1) at the openings you
require for cable entry. Note the arrows in the detector base indicating which
side should be at the top.
2.
If necessary screw the M20x1.5 metal cable gland into the openings.
3.
Install the detector base on a stable, vibration-free surface with two screws.
Mounting/Installation
Installing the detector base
3
12 | 44 A6V10332811_e_en_--