5.
Connect the wires to the terminals for the heating unit(3) according to the
connection diagram.
6.
Install the prism unit(2) on the base with four screws.
3.5 Installing the reflectors for middle distance and
short distance (foil)
WARNING
Danger of falling
Bodily injury
● When installing, use a secured ladder or work platform.
w The installation location of the reflector is defined according to the planning
information.
l Install the reflector with one screw on a level surface. The diameter of the hole
is 4mm.
Mounting/Installation
Installing the reflectors for middle distance and short distance (foil)
3
20 | 44 A6V10332811_e_en_--
To Next Page
Loading...
