Siemens FDL241-9 - Installing the Reflector for Long Distance (Prism)

3.4 Installing the reflector for long distance (prism)
WARNING
Danger of falling
Bodily injury
● When installing, use a secured ladder or work platform.
-
+
-
+
1
2
3
Figure 16: Installing the reflector
1 Base 3 Terminals for heating
2 Prism unit
Mounting without heating unit
w The mounting location of the reflector is defined according to the planning
information.
1.
Install the base(1) with two screws on a level surface.
2.
Install the prism unit(2) on the base with four screws.
a The reflector is installed.
Mounting with heating unit
Note the positive and negative poles.
Only connect one wire per terminal. This is the only way to ensure the connection
is failure-free for the entire service life of the device.
w The mounting location of the reflector is defined according to the planning
information.
w You need a 24 V supply for the heating. Only use cables with a conductor
cross-section of 0.2…1.5mm
2
.
1.
Break open the plastic parts in the base(1) at the openings you require for
cable entry.
2.
If necessary screw the M20x1.5 metal cable gland into the openings.
3.
Install the base with two screws on a level surface.
4.
Insert the cable for the 24 V supply into the base.
Mounting/Installation
Installing the reflector for long distance (prism)
3
A6V10332811_e_en_-- 19 | 44