EasyManua.ls Logo

Siemens Gigaset S790 - Page 52

Siemens Gigaset S790
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
51
Using a handset as a room monitor
Gigaset S790-S795 / en / A31008-M2121-R301-2-3S19 / registr_sett.fm / 22.04.2010
Version 4.1, 21.11.2007
Activating the room monitor and
entering the destination number
v ¢ É ¢ Room Monitor
¤ You can enter data in the following fields:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
ö)
or enter it manually.
Internal number: Select display key
§Change§ ¢. Select handset or Call All to
call all registered handsets
¢ §OK§.
In idle status, the destination number or
the internal destination number displays.
Sensitivity:
Select noise level sensitivity (Low or
High).
¤ Press §Save§ to save the settings.
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination
number
v ¢ É ¢ Room Monitor
¤ Enter and save number as described in
"Activating the room monitor and enter-
ing the destination number"
(
¢ page 51).
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle status, press the display key
§Off§ to
deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support tone
dialing and the room monitor should be set
for an external destination number.
¤ Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There are no further room
monitor calls. The other room monitor set-
tings on the handset (e.g., no ringtone) will
remain activated until you press the display
key
§Off§ on the handset.
To reactivate the room function with the
same phone number:
¤ Turn on the activation again and save
with
§Save§ (¢page 51).
Warning!
u Always check the operation of the
room monitor before use. For exam-
ple, test its sensitivity. Check the
connection if you are diverting the
room monitor to an external
number.
u When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the base/charger. This
ensures that the battery does not run
down.
u Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
i à V
07:15 am
INT 1 Oct 22
Á
Room Monitor
9725551234
Off Options

Table of Contents

Other manuals for Siemens Gigaset S790

Related product manuals