9
Setting the clock
When the appliance is connected for the first time or after a power
cut, the
0 symbol and three zeros flash in the display. Set the
clock. The function selector must be switched off.
Setting procedure
1.Press the
0 Clock button.
12.00 appears in the display and the
0 symbol flashes.
2.Use the + or - button to change the clock.
After a few seconds, the time is saved. The
0 symbol goes out.
Changing from summer to winter time, for example
Press the
0 Clock button twice and change the time using the +
or - button.
Setting the timer
You can use the timer as a kitchen timer. It runs independently of
the oven. The timer has a special signal. This means that you can
tell whether the timer duration or the cooking time has elapsed.
You can also set the timer if the childproof lock is active.
Setting procedure
1.Press the
S Timer button.
The
S symbol flashes.
2.Use the - or + button to change the timer duration.
Default value for + button = 10 minutes
Default value for - button = 5 minutes
The timer starts after a few seconds. The
S symbol lights up in
the display. You will see the time counting down.
When the time has elapsed
A signal sounds. Press the
S Timer button. The timer goes out.
Changing the timer duration
Press the
S Timer button. Use the + or - button to change the
time.
Cancelling the setting
Press the
S Timer button. Press the - button until zero is shown
on the display.
The timer and cooking time count down at the same time
Both symbols light up. You can see the timer duration counting
down in the display.
To call up the
x remaining cooking time, y end time or 0
clock:
Press the
0 Clock button repeatedly until the relevant symbol
appears.
The value you are checking appears for several seconds on the
display.
Childproof lock
Oven
The oven has a childproof lock to prevent children switching it on
accidentally.
Switching the childproof lock on and off
The function selector must be switched off.
To switch on: press and hold the
C key button until the C
symbol appears in the display. This takes about 4 seconds.
To switch off: press and hold the
C key button until the C
symbol goes out.
Notes
■ You can set the timer and clock at any time.
■ If the childproof lock is active, it will be cancelled following a
power cut.
Care and cleaning
With good care and cleaning, your oven will remain clean and
fully-functioning for a long time to come. Here we will explain how
to maintain and clean your oven correctly.
Notes
■ Slight differences in the colours on the front of the oven are
caused by the use of different materials, such as glass, plastic
and metal.
■ Shadows on the door panel which look like streaks, are caused
by reflections made by the oven light.
■ Enamel is baked on at very high temperatures. This can cause
some slight colour variations. This is normal and does not affect
their function. The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough. This will not
impair the anti-corrosion protection.
Cleaning agents
Damage to the various different surfaces caused by using the
wrong cleaning agent can be avoided by observing the following
instructions.
When cleaning the oven do not use
■ sharp or abrasive cleaning agents,
■ cleaning agent with a high alcohol content,
■ scouring pads,
■ high-pressure cleaners or steam jets.
■ Do not clean individual parts in the dishwasher.
Wash new sponges thoroughly before first use.
To Next Page
Loading...
Need help?
General