Hematek
®
3000 System – Instruction Manual – Version 1.343
9. Retain the knurled thumb screw and thin foam sheet together with the
transport container. If the system needs to be transported, these will
provide the best protection.
10. Set the middle cover back in place and close the lid.
Connect power source 11. On the rear side of the system, plug the power cord into the socket, see
Power module on page 4-11.
12. Plug the power cord into a power outlet with a ground contact.
Level system 13. Level the system, see Chapter 8.2.
Start system 14. At the rear of the system, set the main switch to position I, see Main
switch on page 4-11.
15. Start the system, see Chapter 5.1.
Check performance 16. Inspect the drying area for noticeable airflow, see Platen on page 4-8.
17. Make sure that the waste tank is properly installed, see Waste tank on
page 4-6.
18. Make sure that the red waste tank light is off, see Figure 3-1.
19. Place five blank glass slides into the grooves of the conveyor spirals.
20. Allow the glass slides to automatically feed onto the platen.
21. Make sure the leading edge of the glass slides comes into contact with
and activates each of the three sensing switch fingers while moving
along the platen.
As each sensing switch is activated, the
appropriate pump activates after a specific time delay and the pump cap
rotates.
Install pump tubing 22. Install the pump tubing, see Chapter 7.3.2.
Install underplaten tubing 23. Install the underplaten tubing, see Chapter 7.4.
If glass slides are not placed correctly in the grooves of the conveyor
spirals, this can cause them to break
Damage to the system can result.
• Glass slides must be inserted into the grooves of the conveyor spirals
so they are parallel to the slide loading lines inscribed on the platen, see
Slide loading lines on page 4-8.
Note: When first delivered by Siemens, the underplaten tubing is
already installed.
To Next Page
Loading...
