Siemens Hicom 300 H - Page 28

Step by Step
Administration
28
Phone IP Address and Network Mask
Use this function to read or change the current setting
for the phone IP address and the terminal network
mask if DHCP configuration setting is Off  page 27. If
DHCP is On, then the data will be obtained from the
DHCP server during start-up of the phone. The example
below shows programming when DHCP = Off.
Enter Phone IP address and Network Mask
(Text input see  page 41).
Click softkey.
When the phone restarts and DHCP assign is On, the
following values will be obtained from the DHCP server:
• Terminal IP address
• Terminal mask
• Default route
• SNTP IP address
• Time zone offset
A B C
Save
After changing this setting, you will be prompted
to restart the phone. Otherwise the change will
not become effective.
All manuals and user guides at all-guides.com