LME Series Technical Instructions
Document No. LME-1000
SCC Inc. Page 1 Section 9
ACS410 Software Introduction
The LME7 burner control can be completely programmed using either the AZL23 or a PC with
the ACS410 software. Most people find that using the AZL23 is more convenient than the
ACS410 for a “manual” setup of the LME7 parameters. However, the ACS410 has additional
capabilities that are not available with the AZL23 / LME7 alone. These additional, valuable
capabilities are:
1. Saving and printing all LME7 settings and information in a report format. This provides a
convenient, comprehensive startup report.
2. Saving and uploading entire LME7 parameter sets to or from a PC.
3. Viewing and saving trends.
4. Viewing a status screen of the LME7 inputs and outputs as well as the LME7 operating state.
The following pages will cover the software installation and how to connect the LME7 to a PC,
as well as explain how to utilize the basic capabilities of the ACS410 software, including
parameter sets, startup reports, trending, and the status screen.
Since most people prefer to use the AZL23 to set parameters in the LME7, the procedure to do
this with ACS410 will not be covered in this guide. For technical information about how to
program the LME7 through the ACS410 software, email techsupport@scccombustion.com or go
to www.scccombustion.com/lmv3.htm and click on “ACS410 Software Operating Instructions”.
The ACS410 software can be used with the following PC operating systems:
• Windows XP (service pack 2 minimum)
• Windows 7
• Windows 8.1
• Windows 10
ACS410 cannot be used with the following PC operating systems:
• Windows Vista
• Windows ME
To Next Page
Loading...
